the role is very important. in order to ensure the normal continuous operation of the transformer fume purifier and improve combustion efficiency, the transformer fume purifier is for power engineering. so it is passed and maintained and cleaned from time to time. if there will be a failure, the specific steps should be followed to avoid more losses.

detailed introduction to transformer fume purifier

transformer fume purifier is a kind of equipment used to purify transformer fume and

detailed introduction to transformer fume purifier

specific steps to repair the transformer fume purifier

this helps to keep it running normally and extend to and to life. the specific steps for repairing the transformer fume purifier are as follows: the transformer fume purifier needs to be passed, maintained and cleaned from time to time.

• step 1: disconnect the power supply and disassemble the filter element.
• step 2: clean the filter element with thorough detergent and water.
• step 3: dry the filter element and prepare to reinstall.
• step 4: check whether the equipment and wires and buttons are normal.
• step 5: you can install the filter element and power supply again.

the most common transformer fume purifier failures are achieved and solved

the transformer fume purifier may experience some failures. here are some common faults and their problems: daily and in use.

• failure occurs: the device is difficult to start.

  make sure it is not damaged or burned by the wires either.

• failure occurs: equipment and noise are too high. question tips: check and power supply and wires.

  replace damaged parts when necessary.

• a failure occurs: the filter element is blocked. problem tip: check and filter the equipment and the system for damage.

  problem tip: use a thorough detergent to clean the filter element to ensure the normal operation of the transformer fume purifier. reinstall the filter element after drying.

and strong recommendations for maintaining transformer fume purifiers

therefore, it is passed and maintained from time to time. here are some maintenance suggestions:

• clean and replace the filter element thoroughly every certain time.
• check and thoroughly clean the equipment and housing from time to time to ensure that the equipment and ventilation are very good.
• check whether the filter material is aging from time to time. if it is aging, replace it in time.
• ensure the safety of the equipment, power supply and wires to avoid excessive stretching or excessive bending of the wires.

summarize