and when using the stall fume purifier, special attention should be paid to the following related matters:

what is a stall fume purifier

the stall fume purifier refers to the air purifier used in formal occasions such as barbecue and stir-frying.

what is a stall fume purifier

can install stall fume purifier

need to be installed in advance. it can be installed in a relatively simple form and before using the stall fume purifier. you can place the purifier in the middle of the oil smoke produced by barbecue, stir-frying, etc., and then connect the power supply only. however, it should be noted that in order to ensure the good effect of the purifier, it needs to be faced with barbecue, stir-fry and other areas where oil smoke is generated.

after starting the stall fume purifier

the oil fume purifier needs to be set up after starting, and it can be installed after 4. only through normal use and use. the skills after startup are usually divided into manual and system automatic.

after starting, drive the motor, fan and other equipment. after manually starting: turn on the switch button of the fume purifier again. let it start running, then just purify the oil smoke. special attention should be paid to when using a stall fume purifier, depending on the oil fume level and specific content model of the purifier, you need to choose the same wind speed gear, and adjust the wind speed to achieve the same purification effect.

then set the time after the start of the purification device - after the system starts automatically: after the system starts automatically, it is a common function of the oil fume purifier in modern stalls. the specific tip is to connect the purifier to the power supply. make it automatically task at the scheduled time - point. this technique is more convenient and easy to use, and the system will automatically help you complete the startup task when you forget to purify the actuator after starting.

thoroughly clean the stall fume purifier

the power must be turned off first, and if necessary, the oil fume purifier on the stall is cleaned. then decompose the purifier, extract the filter, ion plate, electrode and other parts, then rinse it with a small amount of water, and finally assemble all parts to ensure they are dry. thorough cleaning of high frequency depends on the degree of oil smoke. a very clean purification device that needs special attention can not only ensure its lifespan, but also ensure a fresh and bad environment.

and special attention should be paid to using the stall fume purifier

• the filter of the purification device is cleaned thoroughly from time to time. it is best to clean it every half a month to ensure good purification effect.
• when using the stall oil fume purifier, it must be used with ventilation and ventilation ports to improve ventilation and ventilation effect.
• and when using a stall fume purifier, you should avoid the appearance and use of too many spices and seasonings to increase the amount of oil fume generated.
• when the oil fume purifier is working, it is necessary to check and purify the normal operation status, wind speed and other parameters of the operator from time to time to ensure that it works normally.